Kaisertech - UK Suppliers of Electronic Production Tools & Equipment. Enquiries: [email protected]
UK
Joined December 2011
- Tweets319
- Following1.7K
- Followers1K
- Likes21
Pinned Tweet
It's finally here!!
Take a watch of our Kaisertech brand film over at - youtube.com/watch?v=RlIwhXG0…
Are you experiencing solder splashing on your PCB’s? Discover JBC ALE Automatic Feed Soldering Station 👇
By perforating the solder wire down to the flux core as it’s fed through, the ALE station allows for better flux flow and outgassing., avoiding splashing in the process.
👉Easy To Adapt & Replace
The locking mechanism on these brushes make it simple to replace when required. There are 2 types of brushes you can pick up for your system - metal brushes and fibre brushes.
You can find out more about the JBC range of tip cleaners here!
kaisertech.co.uk/jbc-clmu-au…
... Keep the tip pressed to the tinner for several seconds then use a dry cleaning method to clean the tip.
➞ Repeat steps 2 & 3 until oxidisation has been completely removed. Once this occurs, and the tip shows good wetting capabilities, the process was successful...
If you have exhausted these methods to no avail, it is likely that your cartridge is beyond repair. ❌
In this instance your best bet is to replace the soldering tip.
Find out more information on removing oxidisation from soldering cartridges here:
kaisertech.co.uk/content/blo…
No problem, we are happy to help :) Would be great to see the video!
Thanks to @LemaruX for pointing out the @sdgelectronics video on this (and @KaisertechUK for stocking it). This tripod connects to my JBC vacuum pump and gently pulls up an SMD IC whilst I apply heat, the metal square directs the heat to desolder it.
I need to make a video on it.
