
Being a human and thriving to be the best are part of my nature. Everything else is in God's hands. @2communications π³πππ πππππππ ππ πππππππ
Joined February 2020
- Tweets1.8K
- Following72
- Followers276
- Likes3.3K
Will Balbin retweeted
The Solt Transmitter: Broadcasting on 540 kHz in the medium-wave (MW) band, the station operates with an output power of 2,000 kW.
It transmission line known as a cage line consists of an inner circle of parallel wires that carries the radio-frequency (RF) energy, surrounded by an outer circle of grounded wires that acts as a shield. Located near Solt, Hungary.
Will Balbin retweeted
The Heaviside Layer: A region of Earth's upper atmosphere where ionized gases influence the propagation of radio waves. Beginning approximately 30 miles (50 kilometers) above Earth's surface and extending toward the exosphere, it lies across the upper mesosphere and thermosphere, playing an important role in how radio signals travel over long distances.
Will Balbin retweeted
The Ultra-Low-Noise Maser (ULNA): X-band receiver designed to detect incredibly weak microwave signals returning from deep space. A radio signal traveled millions of miles, touched the surface of a distant asteroid, and came all the way back to Earth. The secret to receiving it was extreme cold.
βIt could listen to signals that ordinary receivers struggled to detect. Inside the system, liquid helium cooled the maser to temperatures approaching absolute zero. Powerful vacuum pumps lowered the pressure, bringing the helium temperature below its normal boiling point of 4.2 kelvin.
Will Balbin retweeted
Radio signals can travel in different ways. Some follow the Earth's surface as ground waves, others travel through the ionosphere as skywaves, and still others travel along line-of-sight paths or through satellites as space waves.
Two important properties determine how these waves behave: frequency and wavelength. Lower frequencies generally have longer wavelengths, while higher frequencies have shorter wavelengths.
This phenomenon is precisely what makes long-range amateur radio so compelling: Under the right conditions, a signal transmitted from a modest HF station can travel thousands of kilometers and reach another operator on the other side of the world.
Will Balbin retweeted
PA0FRI Homemade Pi Filter ATU (14β30 MHz). ATU (Antenna Tuning Unit) used to match the impedance between a radio transmitter (or transceiver) and an antenna system so that maximum power is radiated and minimal power is reflected back into the radio.
Will Balbin retweeted
Boys Learning Morse Code for Military Service: In 1944, a group of students learned to send and receive Morse code at 15 words per minute. Their training began with recorded signals. Eventually, they moved on to actual sending, using telegraph keys and headphones.
The boys couldn't know exactly where these skills would take them. But they were learning a language that could open doors to military service, aviation, navigation, and a lifetime of communications. This was not simply an extracurricular activity. It was practical preparation for a world in which radio communication was essential.
Will Balbin retweeted
In the fall of 1931, two men stood next to a giant machine inside Londonβs Royal Albert Hall. On the left was General Jan Christiaan Smuts, a well-known South African leader. On the right was Colonel Walter Adolphe Vignoles, who helped organize the big Faraday Centenary Exhibition. Between them rose the worldβs largest radio transmitting valve.
Metropolitan-Vickers built the valve for the big Rugby wireless station in England. One of these giant valves was meant to replace about fifty smaller ones. For the first time, a single tube could handle the full power needed to send signals across the ocean.
Smuts was in London to open the Faraday Centenary Exhibition. The event celebrated Michael Faraday, who one hundred years earlier had discovered the science that made electricity and radio possible. The photo of Smuts and Vignoles with the huge valve was sent out by a news agency under the simple headline βWorldβs Largest Radio Valve.β
Will Balbin retweeted
On November 2, 2000, the first permanent crew of the International Space Station (ISS), known as Expedition 1, arrived aboard the orbiting laboratory. The three crew members were NASA astronaut William "Bill" Shepherd (KD5GSL) and Russian cosmonauts Yuri Gidzenko and Sergei Krikalev (U5MIR).
Eleven days later, the crew began amateur radio operations aboard the ISS. The radio setup included an Ericsson handheld VHF/UHF transceiver, a headset with microphone, and a push-to-talk (PTT) switch. The station also included a Terminal Node Controller (TNC) for digital packet-radio communications, along with supporting interface and power equipment.
On November 13, 2000, the ARISS (Amateur Radio on the International Space Station) station was activated, marking the beginning of amateur radio operations aboard the ISS.
Will Balbin retweeted
The HW-7 Low-Power CW Transceiver offered by Heathkit from 1972 through 1975. It was designed for amateur radio operators who wanted to explore the challenge of making contacts with very little power.
The little radio covered three popular amateur bands: 40, 20, and 15 meters. Its solid-state design delivered approximately 3 watts of RF input on 40 meters, 2.5 watts on 20 meters, and 2 watts on 15 meters. Operators could use a built-in VFO or crystal control, depending on their preference.
And there was something special about owning one: you had to build it yourself.
Will Balbin retweeted
Homemade Single-Tube Armstrong Regenerative Shortwave Receiver (1930s-1940s).
The receiver uses a vacuum tube and a feedback coil called a tickler coil to amplify weak signals. The tickler coil is mounted inside the main tuning coil and can be rotated using a front-panel knob. This adjusts the feedback, allowing the operator to control the receiverβs sensitivity and tune in distant shortwave stations.




















