
@NASAAmes | Artemis Lunar Surface Science Team | Geochemistry & Petrology | Mission Ops | Views are my own.
Pasadena, CA
Joined November 2012
- Tweets806
- Following563
- Followers327
- Likes7.9K
Jaw-dropping 3D visualization of all known exoplanets in our cosmic neighborhood! Thinking about all the moons of those planets…
eyes.nasa.gov/apps/exo/#/
45
Mars snowman ☃️
BSE image of a Martian meteorite, with two bright and variably altered Fe-sulfide blebs w silicate inclusions, sitting on a bowl-shaped Cr-spinel crystal and surrounded by Fe-rich olivine below and basaltic glass above, w small quench snowflakes. Scale bar 1 um.
52
4. Having established that we can control fO2 and fH2O equilibrium, we ran a series of cooling experiments to see whether Fe and S speciation adjusted during slow cooling.
We found that for rates as low as ~2000 °C/hr that there was no measurable change in Fe and S speciation.

ALT A figure showing experimental cooling rate on the x-axis versus measured Fe3+/Fe_total (top panel) and S6+/S_total (bottom panel) in experimental MIs. The cooled MIs have indistinguishable and overlapping Fe and S speciation as the MIs that were drop-quenched in water without additional cooling.
1
92
3. A completely unexpected result is that when held at the same fO2, the S-bearing MIs have lower Fe3+/Fe2+ than the S-free Pt-loop glasses.
This is important because many natural melts have 100s-1000s ppm sulfur, yet all of the Fe oxybarometers were calibrated without S...
1
2
101
2. We can simultaneously and precisely control fO2 in the MIs. This is shown by synchrotron XANES measurements of both Fe3+/Fe2+ and S6+/S2- ratios in the quenched glasses, which both follow their redox reaction stoichiometry:
e.g., FeO + 1/4 O2 = FeO1.5, and CaS + 2 O2 = CaSO4
1
96















