Kartikey Pathak (@pathakey) header
Kartikey Pathak (@pathakey) profile picture

electrical engineer and like to build stuff building at @eyecandyrobots

Joined March 2025
we wanted a camera for our trip. fortunately we’re engineers so @novishalno and I built one somehow it make 2026 look like 2006
8
1
3
49
2,019
my contribution to this board was one sentence. GPT-6 Astra chose the parts, drew the schematic and routed it , a 3-phase FOC driver for the axial-flux motor I posted last week. two layers, 12V, three-shunt current sensing. the one thing I specified was where the encoder sits, because that's set by the motor shaft, and there's nothing in a netlist that implies a shaft. it isn't fabbed yet so I don't know if it works. but the thing I keep turning over isn't whether it works. it's that designing it took an evening, and the board takes at least a week or two to fabricate. for as long as hardware has existed, design was the slow step. it isn't anymore , the bottleneck is physical now. fab queues, shipping, and finding out you were wrong a fortnight later. I don't think the next real unlock in hardware is a better model. I think it's turnaround time.
39
20
6
228
17,456
I earlier tried this but the poles at the opposite side of pcb attract and get sticked to pcb will try adding another PCB at the top
1
1
40
no wires, no iron core, just copper spirals etched into PCB 4000rpm on the first proper run @BugejaCarl showed me its possible but mine runs on 3 phases and hope 🫡
22
28
3
340
39,228
this had a hundred ways to go wrong. one wrong line, one bad joint, one shaky move and it's dead. made it anyway. shaped it like the batman logo. plugged it in expecting nothing… and it lit up🦇⚡
1
21
809
cooking up a board that slaps
9
471