Rob Lutter (@roblutter) header
Rob Lutter (@roblutter) profile picture

Not a professional bicyclist from the UK. Dad. Star Wars. Star Trek. 3D Printing. Elder Millennial.

Austin, TX, USA
Joined February 2009
Replying to @shinoblogavi
Whereas on the Snapmaker U1 you can just remove the entire extruder by disconnecting a USB cable and work on it at your desk.
1
436
Replying to @ZombieHedgehog_
Lol maybe that’s not it. Something I use is 75C. I’m just used to picking the filament type and it doing it automatically these days.
1
19
Replying to @DiscussingFilm
This movie is going to lose the Bond role for him to Pattinson
2
44
6,055
Replying to @skyfish_A_
This is from the Star Wars novels of the 80s/90s. All this stuff was later reconned by Disney. Some of them are super good books though I love any Star Wars novel by Timothy Zahn. One of his characters, Thawn, has been brought over to Disney for ‘Rebels’ & ‘Ahsoka’
1
336
Replying to @alfredjviii
Worst take of all time.
28
Replying to @ZombieHedgehog_
Hey @lulzbot3D you’re so fucking back.
28
Replying to @DiscussingFilm
Gen Z loves that there’s no sex scenes likely
1
290
Here I enhanced it with clankers for you (seemed strangely appropriate in this context)
2
34
984
Replying to @YuTR0N
@YuTR0N i know you like the scoops… H3C apparently has at least 1 tool that can use 2.85mm filament. Check out this listing for Bambu’s new 2.85mm TPU 75A (same release date as H3C):
1
1
4
1,209
Replying to @_wurldonfilm
An account with less than 1000 followers citing a parody account.
48
15,204