To think its been 3 years now. Thank fully don't have strikes on my channel this time so I can actually do it in January. Can't wait to talk about all the interesting releases and betas that came out this year. Feel free to stop by at 7 PM CST and join us live Link down below

Maybe I’m not crazy actually

Alignment rod tells me the diameter is slight oversized and a bit off center when threaded but the rod can slide through. Either this ends up being nothing or a horrible catastrophe. Anyways hope I can test it next week

This is a bitch to screw and worse with JB Weld

The new breek arms looks shinier and cheaper but fits properly in old stuff so should be good

Finished before could see spoilers, best of the season easily (very low bar) but idk if I'd include it since it aired all at once. No spoilers but I didn't plan on finishing in a night but I finished it in a night, would watch again

Allow me to introduce myself

I wonder how much this will help

If there is one thing I hope for this weird NFA noncompliance limbo thing it’s that we get a lot of good data from people making printed suppressors. I also feel like it’s going to bring a lot of people who haven’t touched their printer in years back to printing

Don’t forget to re-apply glue for long prints

While I’ve been struggling with nylon this also can happen with all filaments. Wet PLA is also horrible to print with and should also be dried. I remember in the earlier days eSun filament would always ship wet for me and only till I got a filament drier it finally printed well

Unsurprisingly this drying method worked more than fine and my only issue rn is that my PA6-CF seemingly over extrudes way more than it should. Once I simply lowered flow rate by a lot it prints like a dream but still oddly over extruded and under extruded. Still need to figure out why that is since these PETG-CF print like a dream without any real tweaks with the stock .4 nozzle preset on a .6 nozzle with .3 layer hight. The settings aren’t as important at least for PETG and I’ve learned it carries over well to PA6-CF once I lowered the flow rate to 89% (no real test just lowered it manually during a test print till I saw it no longer over extruding). I could run some more calibrations to truly dial in my settings but PA6-CF is expensive and till I function check my prints I’m going to accept that it’s probably good enough